Pearl Drummers Forum - Powered by vBulletin

Search:

Type: Posts; User: Quae Chang

Search: Search took 0.01 seconds.

  1. Thank you!

    Thank you!
  2. Rudimental Ritual on Double Bass (Vision bass drum + Demon Drive Pedals)

    Here's a draft of me playing Alan Dawson's Rudimental Ritual on double bass, using my Pearl Vision bass drum and Pearl Demon Drive pedals. All the details are in the description of my YouTube post. ...
  3. Thread: HQ Tour

    by Quae Chang
    Replies
    1
    Views
    432

    HQ Tour

    Hi Pearl staff,

    Do you guys run tours out of your HQ and/or sell stuff directly from there? I have someone in town nearby you guys asking if you guys do anything like that.

    Thanks!
  4. You may want to give the belts a try for a while....

    You may want to give the belts a try for a while. If you play a lot of DB you may like them better than chains.
  5. The more you play, the more you realize you don't...

    The more you play, the more you realize you don't know as much as you thought and you aren't as good as you thought. I was able to study from Mike Mangini for quite a while before he joined DT. I...
  6. Apparently I did not write my post clear enough....

    Apparently I did not write my post clear enough. This post says I most likely did something wrong. I was asking if I could replace the part, as it looked like a factory bolt, i.e. not something I...
  7. Thank you that's what I was trying to figure out.

    Thank you that's what I was trying to figure out.
  8. Yup. I had two things break in four days last...

    Yup. I had two things break in four days last week. Some of the issues were older but I just found this forum a couple of months ago. Asking questions and learning here. Not exactly sure your point.
  9. Can I get just the top part of snare stand?

    I have a Pearl Vision stand. I went to change snares and I must not have loosened the top part enough because the whole top part came off with the arms attached to the snare. There is a piece missing...
  10. Replies
    1
    Views
    460

    d2500 broken (again)

    I just got this stool as a replacement to my d2k which broke at the base. I just had the exact same problem today (pic 1). When I tried to put it back in place it happened again and the leg broke...
  11. Replies
    20
    Views
    1,719

    I have used Elims straps for years. My slave...

    I have used Elims straps for years. My slave started to fly off. I used duct tape and it worked fine without slowing down my action (and I play a lot of double bass). Although in my case after...
  12. Replies
    3
    Views
    333

    I may need to try it that way to compare it to...

    I may need to try it that way to compare it to when I leave it tight. I love the seat of the d2K. I actually took the seat from that throne and put it on my new d2500. Most comfortable seat I've ever...
  13. Replies
    3
    Views
    333

    Roadster Throne: tighten or no

    This is just a curious question to see what others do. I have a Roadster d2500, previously d2k. I tighten the seat, but I have drums on both sides that require me to turn 90 degrees in each direction...
  14. Replies
    4
    Views
    492

    Thanks for letting me know. i would agree, at...

    Thanks for letting me know. i would agree, at this point it must be the bearings wore out based on looking at everything else.
  15. Replies
    4
    Views
    492

    Eliminator Board sliding side to side

    Hi,

    I have had Eliminator with straps for a while. I'm noticing the foot board sliding side to side. After close examination, everything is tight and where I am pointing to in the picture is the...
  16. Replies
    3
    Views
    596

    Is this covered under warranty?

    Is this covered under warranty?
  17. Replies
    3
    Views
    596

    I am sure. I got on the floor and pushed the...

    I am sure. I got on the floor and pushed the pedals with my hands. I had to hold the pad and push down on it to stop the rattling. It seems like it either doesn't stay stable, or the nuts/bolts are...
  18. Replies
    3
    Views
    596

    BD 10 rattling

    Hi,

    I have a BD 10 practice pad that really rattles when I give it a good strike with a pedal. I have everything tight. Is this an issue of the bolts stripping, or do I need to weigh it down, etc....
  19. Replies
    1
    Views
    328

    D-2k Roadster Help

    Hi, the bottom of my throne came off. After investigation, it looks like the top part of the bottom pipe needs to be inside the clamp (where I'm pointing in the picture). I do not see any allen...
Results 1 to 19 of 19